Table of Contents
Advertisement
1
Getting Started
6 Press
7 If you intend to program over LAN or use such programs, make sure you have
8 Use the Connection Expert utility of the IO Libraries Suite to add the power
If you have installed other I/O software, refer to documentation that
NOTE
accompanies the software.
9 You can use various programming environments to control the power meter.
Configuring the LAN Remotely
To automatically configure the LAN settings enable DHCP operation using the
SYSTem:COMMunicate:LAN:DHCP[:STATe] command.
To individually specify the settings use the following commands:
– SYSTem:COMMuniucate:LAN:ADDRess
– SYSTem:COMMunicate:LAN:SMASk
– SYSTem:COMMunicate:LAN:DGATeway
– SYSTem:COMMunicate:LAN:AIP[:STATe]
– SYSTem:COMMunicate:LAN:RESTart
46
A pop-up appears for 5 seconds (see
bottom of the Remote Interface display to see when the server has assigned an
address.
, to return to a measurement screen.
installed I/O software on your PC.
meter and verify a connection.
For an overview about programming instruments via LAN, refer to the
connectivity guide.
Figure
1-3). Monitor the Status at the
Keysight N1913/1914A Installation Guide
Advertisement
Table of Contents
