Keysight EPM Series Installation Manual page 44

1 Getting Started
Auto IP Mode
Use this procedure if you require local PC Control or you are working in an isolated
(non-site) LAN.
1 Connect the computer to the power meter.
2 Switch the power meter on.
3 Press
4 Press Network AutoIP if you need to set any optional settings.
5 Press Restart Network.
6 Press
7 If you intend to program over LAN or use such programs, make sure you have
8 Use the Connection Expert utility of the IO Libraries Suite to add the power
If you have installed other I/O software, refer to documentation that
NOTE
accompanies the software.
9 You can use various programming environments to control the power meter.
44
, Remote Interfaces to display the Remote Interface display (see
Figure 1-2). Ensure that AutoIP is checked.
A pop-up appears for 5 seconds (see
bottom of the display to see when the server has assigned an address.
, to return to a measurement screen.
installed I/O software on your PC.
meter and verify a connection.
For an overview about programming instruments via LAN, refer to the
connectivity guide.
Figure 1-3). Monitor the Status at the
Keysight N1913/1914A Installation Guide