Tractor Requirements; Rops And Seat Belt; Tractor Safety Devices - Schulte V1280 Operator's Manual

Table of Contents

Advertisement

2. TRACTOR REQUIREMENTS

The tractor used to operate the mower must have the power capacity to lift, pull, and operate the Power Take
Off (PTO) at the mower's rated speed while traveling at a ground speed between 2 and 5 MPH. Operating the
mower with a tractor that does not meet the following requirements may cause tractor or mower damage and
be a potential danger to the operator and passersby.
Tractor Requirements and Capabilities
ASABE approved Cab with Protective Structure and seat belt.
Tractor Safety Devices .................... Slow Moving Vehicle (SMV) emblem, lighting, PTO master shield
Tractor Horsepower -Minimum ........ 60 HP
Drawbar............................................ 14" length for 540 RPM unit, rated to carry weight of mower, safety
Drawbar Vertical Load Capacity ....... 1298 lbs.
Hydraulics ........................................ Minimum of 2 Remotes
Front End Weights............................ As needed to maintain 20% weight on front axle
Power Take Off ................................ 540 RPM (6-spline 1-3/8" diameter output shaft)

2.1 ROPS and Seat Belt

The tractor must be equipped with a Factory Cab and seat belt to protect the operator from falling from the
tractor and being crushed or run over by the tractor and/or implement resulting in serious injury or death. Only
operate the tractor while seated in the operator's seat with the seatbelt securely fastened around the operator
OPS-U- 0051

2.2 Tractor Safety Devices

If transporting or operating the tractor and implement near a public roadway, the tractor must be equipped with
proper warning lighting and a Slow Moving Vehicle (SMV) emblem which are clearly visible from the rear of
the unit. Lights and a SMV emblem must be equipped directly on implements if the visibility of the tractor
warning signals are obscured.
Maintain all manufacturer equipped safety shields and guards. Always replace shields and guards that were
removed for access to connect, service, or repair the tractor or implement.
with the PTO master shield missing or in the raised position. OPS-U- 0004
V1280 07/16
© 2016 Alamo Group Inc.
OPERATION
chain attachment point
Operation Section 4-4
Never operate the tractor PTO

Advertisement

Table of Contents
loading

Table of Contents