Back Panel
The cable connections for the RASFinder are made on the back panel. Three groups of cables are
used on the RASFinder: the Command port, three RJ-11 ports (Links 1, 2, and 3), and the Ethernet
port. The cable connections are shown in Figure 1-3 and defined in the following groups.
Link Connectors (Links 1, 2, and 3)
These Link connectors are used to connect the RASFinder to a WAN. These connectors are RJ-11
connectors.
Ethernet 10Base-T Connector
The Ethernet 10Base-T connector is used to connect the RASFinder to a LAN using unshielded
twisted cable. This connector is an RJ-45 jack.
Command Connector
The Command connector is used to configure the RASFinder using a PC with a serial port and
running Windows
provided to convert to a standard serial port DB25 female connector.
Power Connector
The Power connector is used to connect the external power supply to the RASFinder. The Power
connector is a 6-pin circular DIN connector. A separate power cord is connected to the power supply
and the live AC grounded outlet.
MTASR3-200
Figure 1-3. Back Panel
®
software. The Command connector is an RJ-45 jack and a short adapter cable is
Chapter 1 - Introduction and Description
9