Table of Contents
Advertisement
Introduction
This chapter is organized to provide instructions for unpacking and cabling your RASFinder. The
unpacking section describes the contents of the shipping box and shows how the RASFinder is
packaged. The installation procedure describes each cable connection and shows where that cable is
connected to the RASFinder. If additional RAM is needed on your RASFinder, a detailed procedure is
provided describing how to install a second SIMM.
Unpacking
The shipping box contains the RASFinder, external power supply, a plastic bag containing cables,
RASFinder CD with the RASFinder Software, Quick Start, and User Guide in Adobe Acrobat
format. Inspect the contents for signs of any shipping damage. If damage is observed, do not power
up the unit; contact Multi-Tech's Technical Support for advice (refer to Chapter 7). If no damage is
observed, place the RASFinder in its final location and perform the procedures in the section on
"Cabling Your RASFinder."
Save the shipping box in case reshipment is necessary.
Safety Warning Telecom
1. Never install telephone wiring during a lightning storm.
2. Never install a telephone jack in wet locations unless the jack is specifically designed for wet
locations.
3. This product is to be used with UL and cUL listed computers.
4. Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
5. Use caution when installing or modifying telephone lines.
6. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a
remote risk of electrical shock from lightning.
7. Do not use the telephone to report a gas leak in the vicinity of the leak.
8. To reduce the risk of fire, use only 26 AWG or larger telecommunication line cord.
MTASR3-200
Figure 2-1. Unpacking
Chapter 2 - Installation
TM
12
Advertisement
Table of Contents
