Multitech RouteFinder MTASR3 User Manual page 41

Chapter 4 - RASFinder Software
from a RAS application to a routing application.
The PPP/SLIP (Point-to-Point/Serial Line Internet Protocol) button displays the PPP Port Setup
dialog box with the WAN 1 tab active. In the Remote Port Setup group in the lower right of the dialog
box, change from the Client only option to the Client or LAN (as shown below); this disables the
Client only option, and enables the RASFinder to communicate with either a remote client (PC) or a
LAN. The WAN 2 and WAN 3 tabs must have the Client or LAN enabled for both of these ports, too.
To bond the three WAN ports together, tripling the transfer rate between two LANs, click the Advanced
tab and enable the MLPPP (MultiLink Point-to-Point Protocol) option. Then return to the main menu.
MTASR3-200 41