Table of Contents
Advertisement
Back Panel
The cable connections for the ProxyServer are made at the back panel. Three groups of cables are
used on the ProxyServer -- the Command Port, ISDN, and Ethernet. The cable jacks are shown in
Figure 1-3 and defined in the following groups.
ISDN Connector
The ISDN connector (an RJ-45 jack) is used to connect the ProxyServer to the WAN.
Phone Connector
The PHONE connector (an RJ-11 jack) can be used to connect an analog telephone, fax machine, or
modem to your ProxyServer.
Ethernet 10Base-T Connector
The Ethernet 10Base-T connector (an RJ-45 jack) is used to connect the ProxyServer to a 10 MB
LAN using unshielded twisted cable.
Command Port Connector
The Command connector (CMD) is used to configure the ProxyServer using a PC with a serial port
and running Windows software. The Command connector is an RJ-45 jack and is used with the RJ-
45 to DB-9 command port cable provided with your ProxyServer. The command port is only used to
connect the ProxyServer directly to the PC for local configuration and management.
Note: If your PC has a DB-25 (25-pin) serial port connector, you will need to obtain a DB-9 (9-pin,
male) to DB-25 adapter. Connect the DB-25 end of this adapter to the serial port on your PC, and
then connect the DB-9 (9-pin, female) end of the Command Port cable to the adapter.
Power Connector
The POWER connector (a 6-pin circular DIN connector) is used to connect the external power supply
to the ProxyServer. A separate power cord is used to connect the power supply to a live AC
grounded outlet.
On/Off Switch
The power switch applies DC power to the ProxyServer.
MTPSR1-202ST
Chapter 1 - Introduction and Description
COMMAND PORT
ISDN
PHONE
10BASE T
Figure 1-3. Back Panel
ON
POWER
OFF
9
Advertisement
Table of Contents
