Multitech RouteFinder MTASR3 User Manual page 35

Chapter 4 - RASFinder Software
network. The address assigned to the Ethernet port of the RASFinder can be any address that is
recognizable by your network's backbone.
After you enter your LAN IP address information and three sequential WAN addresses have been
automatically placed in the Remote address for WAN 1, 2, and 3 fields, ensure that the Enable IP
Routing on WAN 1, 2, and 3 are checked. This activates the WAN ports to receive calls from the
remote users. At this point, the software will be downloaded to the RASFinder and then you will need
to go in through the main menu and set up the conditions for the Radius security services.
To enable the Radius security services, you need to establish communications between the Radius
server and the RASFinder. The Radius security service options are defined on the Radius Setup
dialog box. To provide vendor-specific configuration for the Radius server, you need to bring up the
main menu, hit the PPP/SLIP button, and click the RADIUS button in the PPP Port Setup dialog box.
The Radius Setup dialog box enables the RADIUS option, establishes accounting, enables call if
security server is down, assigns a remote address using the RADIUS, provides a window for the
shared secret, and indicates the primary RADIUS server IP address. The new vendor specific
attributes and services that you establish for the RASFinder can not conflict with any standard Radius
MTASR3-200 35