Table of Contents
Advertisement
Chapter 5 - RAS Dial-Out Redirector
Note: If the software redirector is set up as IPX, the IPX option must be selected in the
Applications Setup dialog box. If the software redirector is set up as IP, the IP option must be
selected.
9. The COM Port to MCSI Mapping window displays.
Click Add Port to add a port to the MCSI Port list.
If you want a specific line, click a COM port in the MCSI Port list, then click the line to which you
want to map that particular COM port. The status message "Mapped to MCSI" should appear
above the MCSI Port list.
Click Remove Port to permanently remove a port from the Local Port list box.
Click Unmap to unmap a line.
Click Search to search for lines on a server.
Click Close when finished.
At this time your WINMCSI software installation is complete. Proceed to the next section,
"Running the WINMCSI Workstation Software".
MTASR3-200
62
Advertisement
Table of Contents
