Table of Contents
Advertisement
the NetGuardian as a PPP (Point-to-Point Protocol) server via dial-up.
To configure the NetGuardian as a PPP Server:
1. Select
from the
PPP
In the
2.
section
Server
3. Set the IP address that is given to the guest dialing in. (This must be a valid and available IP address for the
subnet on the LAN you will be connecting to, the same one the NetGuardian is connected to.)
4. Click
to save your PPP settings.
Submit Data
Edit the Modem settings for the PPP server in the Edit menu > Ports screen > Modem section
5.
Select
from the
Ports
6. Scroll down to the
Modem
7. In Answer Init String field type
8. Click
to save your Modem changes.
Submit Data
Select PPP and Telnet access privileges in the Edit menu > Logon > Logon Profiles screen
9. Make sure the users who will need it have the access privilege to access the unit via Telnet. Select
the
menu.
Edit
menu.
Edit
check the
Enable Server
menu.
Edit
section. Make sure the
.
&Q6
(also known as Hosting Mode) box.
field is greater than 0.
Ring Count
43
in
Logon
Advertisement
Table of Contents
Need help?
Do you have a question about the NetGuardian 420 and is the answer not in the manual?
Questions and answers