WAGO I/O-SYSTEM 750 510 376 07 Quick Start Manual page 16

Ethernet starterkit 2

Table of Contents

16 •

Quick Start

The First Program

You can change the position of a module in your selection by selecting and

moving the module using the up and down arrow buttons on the right-hand

side of the window.

The 750-600 end module is not shown in the I/O configuration window.

Then confirm your selection with "OK".

For each I/O module, you can now determine via

outputs of a module will be controlled by the controller (PLC) or by a particu-

lar Ethernet protocol (fieldbus 1 = Modbus/TCP or fieldbus 2 = Ethernet/IP)

(Fig. 14).

Fig. 14: WAGO-I/O-PRO CAA, PLC configuration with 750-400 and -501

In this example, we first used the "PLC" value.

The I/O configuration window now shows the address of each channel, and

thus each individual bit on the module.

Module parameters if the

WAGO-I/O-SYSTEM 750

ETHERNET StarterKit 2

Table of Contents