12.
Remove the jack stands.
13.
Raise the deck and install the height-of-cut pin.
14.
Check that the machine does not creep in
neutral when you disengage the parking brakes.
Adjusting the
Motion-Control Damper
You can adjust the top damper mounting bolt to obtain
a more desired motion-control lever resistance. See
Figure 87
for mounting options.
Figure 87
Right motion-control lever shown
1. Torque the locknut to 23 N∙m (17 ft-lb). The bolt must
protrude past the end of the locknut after torquing.
2. Most resistance (firmest feel)
3. Damper
4. Medium resistance (medium feel)
5. Least resistance (softest feel)
Adjusting the
Motion-Control
Neutral-Lock Pivot
You can adjust the flanged nut to obtain the desired
motion-control lever resistance when you move them
to the N
EUTRAL
adjustment options.
1.
Loosen the jam nut.
2.
Tighten or loosen the flanged nut to the desired
feel.
Note:
For more resistance, tighten the flanged
nut.
Note:
For less resistance, loosen the flanged
nut
3.
Tighten the jam nut.
g008620
1. Flanged nut
60
-
position. See
Figure 88
LOCK
Figure 88
2. Jam nut
for
g008621