System Check - Micromeritics GEMINI VII KEYPAD Operator's Manual

S C
YSTEM HECK
Adsorptive Line Test on page 4 - 3
This test verifies that all instrument components are operating properly. This test requires
operator attention. The instrument will beep when attention is required.
Before beginning this test, ensure that the:
sample tubes or plugs are installed on the sample and balance ports.
n
helium gas inlet is plugged or if helium is attached, the regulator shut-off valve is closed.
n
adsorptive gas in attached to its inlet port.
n
vacuum pump is installed.
n
Press ENTER to start the test.
When the test is finished, press ENTER.
Gemini VII Keypad Operator Manual
239-42801-01 (Rev E) — July 2021

System Check

4 - 9