Po Command - Micromeritics GEMINI VII KEYPAD Operator's Manual

3 Command Prompts
P C
O OMMAND
Alt + . (decimal)
Press CHOICE to display the options. Press ENTER to select.
Use to measure the saturation pressure (Po). Applicable for the 2390p or 2390t models only.
Choices: Sample Tube, Po Tube
If Sample Tube is selected, ensure that empty sample tubes of the same size are installed on the
analysis port and balance port. It is not necessary to install tubes on both ports if Po tube is
selected.
Select the preferred method for measuring the saturation pressure.
This prompt displays when using the 2390a model:
Before beginning, ensure that empty sample tubes of the same size are installed on the analysis
port and balance port. To begin measuring the saturation pressure, press ENTER.
Status messages display while the saturation pressure is being measured, and the saturation
pressure is stored in memory and used in report calculations.
Gemini VII Keypad Operator Manual
3 - 50
239-42801-01 (Rev E) — July 2021