Spot Cleaning; Manual Control; Scheduled Cleaning - Tesla RoboStar iQ400 User Manual

FIRST START
SMART CLEANING
1. This is the most used cleaning method. The device uses dynamic gyroscopic navigation and thus
moves along a cleaning route that is optimized for the best cleaning of the floor.
2. Press the "2" button to "Start cleaning" on the robot vacuum or press the "1" or "2" button on the
remote control. When cleaning is started, the robot vacuum cleaner should always be in the
charging station.
3. To interrupt cleaning/stop the robot vacuum cleaner, press the "2" button on the robot vacuum
cleaner or press the "2" button on the remote control.
CLEANING ALONG THE WALL
Place the robotic vacuum cleaner near the charging station and press the "5" button on the remote
control "Change cleaning mode" and choose cleaning "Along the wall". The robotic vacuum cleaner
cleans the area around the perimeter of solid objects (e.g. walls).

SPOT CLEANING

Place the robotic vacuum cleaner near the dirty place and press the "5" button on the remote control
"Change cleaning mode" and select cleaning "Spot cleaning".

MANUAL CONTROL

Press the "Directional buttons" on the remote control and control the robotic vacuum cleaner with the
arrows.
TIME SETTING
Press the "7" button on the remote control to enter the "Time Setting" mode. First, set the hour with the
˄ and ˅ buttons. Then press the > button and set the minutes in the same way. Confirm the set values
by pressing the "7 " button.

SCHEDULED CLEANING

The robotic vacuum cleaner can be programmed to clean automatically once a day at a specified time,
even if no one is home. Press the "3" button on the remote control. First, set the hour with the ˄ and ˅
buttons. Then press the > button and set the minutes in the same way. Confirm the set values by
pressing the button "3". To cancel the scheduled cleaning, press the "3" button for three seconds. If
you turn off the robot vacuum cleaner by pressing the "2" button on the robot vacuum cleaner, the
scheduled cleaning will not be carried out, it must be set again.
RETURN TO THE CHARGING STATION
After pressing the "8" button on the remote control, the robotic vacuum cleaner will search for the
charging station and start charging automatically. In standby mode, the robotic vacuum cleaner
consumes very little, so we recommend not turning off the power supply to the charging station.
MAGNETIC TAPE
If you want to avoid cleaning the selected part, use the magnetic tape included in the
TESLA RoboStar iQ400 package. Before starting cleaning, place it or even better stick it (with double-
sided adhesive tape) where you do not want the robotic vacuum cleaner to drive. You can, for example,
prevent passage into the next room, prevent running into a high-pile carpet, protect fragile objects, etc.