Spot Cleaning; Scheduled Cleaning - Tesla RoboStar iQ700 Manual

cleaned area when the cleaning is complete. The robot vacuum cleaner should always be in the
charging station and its battery should be fully charged when the cleaning starts.
•
Press the "3" button on the robotic vacuum cleaner to start Smart Cleaning (Auto), in which the
TESLA robotic vacuum cleaner uses advanced laser navigation for optimised movement in space.
This is the most commonly used cleaning method.
•
This Smart Cleaning can also be started in the app, click on "Auto" and then on "Start". To
pause/stop the cleaning, press "3" on the robot vacuum cleaner again or click on "Pause" in the
app.

SPOT CLEANING

Click on "Site Cleaning" in the app. Use your finger to select the location on the map that you want the
robot vacuum cleaner to clean. The robotic vacuum cleaner will drive from the charging station to the
designated location on the map and clean the area around the designated location, approximately 1.6 x
1.6 metres. When the cleaning is complete, the robotic vacuum cleaner returns to the charging station.

SCHEDULED CLEANING

The robotic vacuum cleaner can be programmed to clean automatically once a day at a set time, even
when no one is home. This option can be found in the app under "Settings". If you switch off the robot
vacuum cleaner by pressing the "3" button on the robot vacuum cleaner, the scheduled cleaning will
not be carried out, it must be set up again.
WATER MOP
Place the robot vacuum cleaner outside the charging station and press the "3" button to turn it off.
•
Open the plastic cap and fill the water tank. Only refill the water tank after removing the tank from
the body of the robot vacuum cleaner. A slight leakage of residual water may occur when handling
the tank. In this case, wipe up the spillage immediately with a dry cloth.
•
Install the mop cloth on the mop holder. Lightly dampen the mop cloth with water for faster and
smoother wiping. If the mop cloth is dirty after cleaning, you can gently wash it in lukewarm water.
•
Carefully insert the tray with the mop cloth holder installed into the body of the robot vacuum
cleaner. Do not pour water over the robot vacuum cleaner or its interior, the robot vacuum cleaner
is not waterproof.
•
Three levels of water wipe cleaning can be set in the phone app.
•
Do not leave the robotic vacuum cleaner standing still or with water residue in the water tank.
•
Keep enough water in the water tank for wiping, or rinse the mop if necessary.
•
When you have finished cleaning, always empty the remaining water from the water tank, rinse it
and dry the mop cloth.
•
We recommend wiping the floor with clean lukewarm water, as the cleaner may cause foaming
and worsen the water dripping onto the mop cloth or cause streaks on the floor after it has dried.