Cleaning And Maintenance - Tesla LifeStar UV550 User Manual

WARNING
•
To prevent accidental injury, the UV lamp must be placed within 5 cm of the irradiated object and
the inclination of the device must not exceed 30 degrees. Outside this range, the UV lamp turns
off automatically.
•
When using the UV lamp mode, do not touch the hot air outlet with your hands.
You can switch off the device at any time during use by pressing the „2" button.

CLEANING AND MAINTENANCE

Failure to clean can damage the vacuum cleaner!
Before cleaning, disconnect the mains plug from the mains socket. Clean the body of the vacuum
cleaner with a damp cloth and then make sure that it is dry. Do not use solvents or abrasive cleaners.
Cleaning the dust tank
Switch off the appliance, unplug it from the socket, press the dirt tray release button and remove the
dust tray assembly. Release the top cover of the dirt tray, remove the filters and empty the contents of
the tray. Wash the multi-function and cyclone filters with warm water. Allow it to dry properly before
reinstalling. After cleaning, reattach to the unit.
Cleaning the washable filter
The maximum suction effect will always be achieved with a clean filter and an empty dirt tank. Wash
the filter under running water, do not use hot water or detergents.
CAUTION: A bagless vacuum cleaner requires regular cleaning of the filters. Failure to clean the filters
properly can reduce or block airflow, which can lead to overheating and subsequent equipment failure.
The filters must always be completely dry before use. Do not operate the equipment without the filters
inserted. We recommend cleaning the filters of the device after each use. If the dirt container is full,
clean it immediately.
Cleaning the rotary brush
Loosen the screws of the rotating brush cover and remove it. Carefully cut with scissors to remove any
fibers or hair. After cleaning the brush, replace the cover and secure it with the screw.
UV lamp cleaning
To loosen it, unscrew the two screws and remove its cover. Gently clean the UV lamp with a dry soft
cloth. After cleaning, replace the UV lamp cover and secure it with two screws. Any dust or grease on
the UV lamp will immediately reduce its permeability and therefore the UV lamp must be cleaned
regularly. Do not touch the UV lamp with bare hands, as you will leave a mark on its surface, which will
impair the transmission of sterilizing light.
If you will not be using the appliance for a long time, please store it in a dry and cool place, do not store
the appliance in a humid environment or in direct sunlight.