Care And Cleaning - Tesla BG300G User Manual

2 in 1 crevice/brush nozzle and upholstery tool
1. Connect the crevice/brush nozzle or upholstery tool to the end of the handle (12) or
to the telescopic suction tube (14).
2. Use the upholstery tool to vacuum upholstery.
3. To clean hard to reach corners keep the nozzle folded and use it as a crevice nozzle.
4. To use the nozzle as a brush nozzle, pull the brush section in the direction of the arrow
until it locks in place (Fig.4).

CARE AND CLEANING

1. Do not use alcohol, acetone, benzene, scouring cleaning agents, etc. to clean the synthetic parts of the appliance. Do
not use hard brushes or metal objects.
2. Do not immerse the appliance or power plug in water or any other liquids.
3. Wipe the outside of the appliance regularly with a slightly dampened cloth and dry afterwards with a soft cloth.
Dust bag replacement
1. Hold the suction hose during operation up into the air. If the dust bag full indicator
(9) shows red, the dust bag (21) is full and needs immediate replacement.
2. Switch OFF the appliance and pull the plug from the mains power outlet socket.
3. Pull the cover release button (25) and lift the cover (23) until it locks in place (Fig.5)
4. Carefully pull upwards the dust bag holder (A) including the dust bag.
5. Slide the used dust bag out of the dust bag holder. Dispose of the dust bag in
accordance with local regulations.
6. Slide a new dust bag into the dust bag holder. Pay attention to the arrow on the
dust bag, which must point to the bottom of the dust bag holder.
7. Reinsert the dust bag holder (A) with the dust bag carefully into the dust
bag compartment until it locks in place. Align the dust bag evenly inside the
compartment.
Filter maintenance
Your appliance is equipped with two filters. A motor filter (inlet filter) and an exhaust
filter. Both filters need regular maintenance as per below instructions.
Motor filter
1. Clean the motor filter (B) when changing the dust bag. The motor filter is
washable.
2. The motor filter is located in the rear section of the dust bag compartment (Fig.6).
Pull the filter holder upwards to detach filter holder and filter (Fig.7)
3. Push the motor filter out of the filter holder.
4. Wash the motor filter in clear warm water. Do not add any cleaning agents as they
damage the filter.
5. After washing, dry the motor filter completely. If necessary, let it dry in the air.
6. Insert the motor filter into the filter holder and place the filter holder back to its
original position.
NOTE
The filter holder can only be inserted in one Direction.
7. Close the cover.
6
Fig. 4
Fig. 5
Fig. 6
Fig. 7