Table of Contents
Advertisement
CLEANING AND MAINTENANCE
In order not to affect the performance of the machine, it is recommended that you maintain its components on a
regular basis.
Before cleaning the main body (the engine block) (the holding section), make sure the machine stops working and the
product is not in recharging.
Scrub with water or neutral detergent. Before scrubbing, ensure the cloth is dry. Do not infiltrate water into the internal
parts of vacuum cleaners (Fig. 19) After cleaning, do not to put it under the direct sunlight or in wet place.
Cleaning dust barrel
Once the amount of dust reaches the "MAX" value, please clear it as soon as possible and do not overfill it.
In order to make it easier to empty the dustbin, it is recommended that you remove the aluminum pipe or other
accessories before cleaning.
After the machine is stopped, open the dust barrel cover and dump the dust. If any stubborn dirt is found in the inner
wall of the dust barrel, please wipe it carefully with a wet rag.
After cleaning, close the dust barrel cover and make sure the lock button is in place.
After wiping the inner wall of the dust barrel with wet rag, it is necessary to be placed under the sun,
NOTE
and then cover the dust barrel after thoroughly drying.
Cleaning the outlet filter
In order to ensure the performance of the product, it is recommended that you regularly clean it and replace it after 3-6
months. (depending on the usage), press and hold down the dust barrel release button, remove the body and turn the
cover, remove the sponge, and dust off the sponge filter. (see Fig. 16)
If dust is accumulated too much, wash it thoroughly and dry it before loading it into the main body.
During washing the sponge filter, use cold water and dry it thoroughly (usually in sunlight
NOTICE!
for 24 hours, then put it back into the body.
Cleaning brush
It is recommended that the brush be cleaned once after 4-5 times of operation with electric brush:
1. Turn off the power and remove the electric brush.
2. Flip the brush and turn the lock button on the fixed cover with a coin to open the lock. (Figure 20)
3. Remove the roller brush to fix the cover plate, lift one end of the roller brush and pull out the roller brush. (Figure 21)
4. Use a pair of scissors or other sharp instrument to remove tangled animal hair and other waste (Figure 22).
5. When the cleanup is complete, push one end of the rolling brush into the floor brush and then clip the other end
into the floor brush. (Figure 23)
6. Cover the cover and lock it.
Figure 19
11
Advertisement
Table of Contents
