Charging The Battery - Tesla RoboStar iQ400 User Manual

REMOTE CONTROLER
BEFORE FIRST CLEANING

Insert the batteries into the remote control, making sure to observe the correct polarity.

Install the side cleaning brushes, left and right.

Remove the two foam stops located on the side of the robotic vacuum cleaner bumper.

Before starting cleaning, prepare the room so that there are no objects left on the floor that could
hinder the operation of the robotic vacuum cleaner (larger papers, cables, stickers, small objects,
inappropriately placed carpet, etc.). Move chairs and other larger objects away so that the robotic
vacuum cleaner can easily reach hard-to-reach places.

Also remove objects that can damage the operation of the robotic vacuum cleaner.

Direct sunlight can cause reduced sensitivity of the robot vacuum cleaner's infrared sensors,
please avoid direct sunlight.

Black furniture may not be properly detected due to the physical nature of infrared sensors.
A slight impact may therefore occur, which will be dampened by the front bumper.

CHARGING THE BATTERY

Ideal location of the charging station
There must be no obstacles within 1.5 meters in front of the front of the charging station, and within
0.5 meters on the sides. A mirror or other objects with a strong reflection cannot be placed in the area
of the charging base 15 cm above the ground. The base should not be exposed to direct sunlight. Make
sure the charging station is within range of a good quality and strong Wi-Fi signal so it can connect to
a Wi-Fi network while charging.
1. Connect the charging station to an electrical outlet.
2. Place the robotic vacuum cleaner in the charging station so that the battery of the robotic vacuum
cleaner will start charging automatically and the "1" button on the top panel of the robotic vacuum
cleaner will flash slowly. When the battery is fully charged, this button will be lit continuously.
1 SMART (intelligent) cleaning
2 Start/Stop cleaning
3 Scheduled cleaning
4 Display
5 Changing the cleaning mode
6 Direction buttons
7 Time setting
8 Return to the charging station