Using A Vacuum Cleaner; Cleaning And Maintenance - Tesla AeroStar T500 User Manual

USING A VACUUM CLEANER

Before using the vacuum cleaner, first pull out a sufficient length of the power cord and connect it to
the mains socket. The yellow mark on the network cable is the maximum length that must not be
exceeded. To turn on the device, press On/Off button (8). To insert the power cord back into the
vacuum cleaner, press the Cable rewind button (9). Hold the cord with one hand and guide it to avoid
injury. Use the button to regulate the engine's suction power (10).

CLEANING AND MAINTENANCE

Before cleaning, disconnect the mains plug from the mains socket. Clean the vacuum cleaner with a
damp cloth and then make sure it is dry. Do not use solvents or abrasive cleaners.
The maximum suction effect will always be achieved with clean HEPA filters and an empty dust tank.
We also recommend cleaning the HEPA filters after each emptying of the tank. When vacuuming very
fine dust, the pores of the filters may become clogged. This can reduce air permeability and reduce the
suction power of the vacuum cleaner. Therefore, in such a case, it is advisable to clean the filters even
if the dust tank is not yet full.
CLEANING THE INPUT AND OUTPUT HEPA FILTER
1. Switch off and unplug the vacuum cleaner.
2. Remove the dust tank.
3. Press the latch to open the tray (1) and remove the HEPA inlet filter.
4. Open the HEPA outlet filter cover on the vacuum cleaner and remove the HEPA outlet filter (2).
The universal floor nozzle with a pull-out brush is designed for all
types of floors. When vacuuming smooth hard surfaces, pull out the
brush and when vacuuming carpets, slide it in.
Slotted tube - for radiators, corners, strips, etc.
Upholstery nozzle - for sofas, beds, upholstered armchairs, etc.