6.2.2.2
Assigning network parameters
In the "Home" tab, you can assign the network parameters for MF devices under "Accessible
MF devices":
1. Click "Start scan" to find MF devices via the preset network interface.
2. Select an MF device.
With "Flash LED", you can flash the LEDs of the MF device for identification.
3. Enter a device name, valid IP address and the subnet mask.
4. If you use a gateway, you can enable the "Use router for gateway" option and enter the
router address.
5. Click "Assign network parameters".
The network parameters are assigned.
PN/MF Coupler
Hardware Installation and Operating Manual, 07/2020, A5E50018670-AA
6.2 Integration into the automation system
EtherNet/IP
61