Table of Contents
Advertisement
Properties
The PN/MF Coupler has the following properties:
• Data exchange between an EtherNet/IP scanner and a PROFINET IO controller across
network boundaries while fully maintaining network separation, which means no support
of routing functions.
• Data exchange between two PROFINET IO controllers across network boundaries while
fully maintaining network separation, which means no support of routing functions.
• Compatible with the PN/PN Coupler V4.2 (except data set coupling, local coupling,
MSI/MSO module, Shared Device, S2 redundancy, IRT and MRDP)
• Maximum of 16 input areas/output areas for exchange of data with the following virtual
modules:
– IN
– OUT
– PROFIsafe IN/OUT
• Electrical isolation between the two PROFINET IO subnets
• Electrical isolation between the EtherNet/IP network and the PROFINET IO subnet
• Redundant power supply
• Supply voltage 1L+/2L+ 24 V DC (SELV/PELV)
• Usable BusAdapters
– BA 2×RJ45 for RJ45 bus connector
– BA 2×FC for direct connection of the bus cable
– BA 2xM12 for bus cable with M12 plug
• Diagnostics interrupts
• Extended channel diagnostics
• Status information of the input user data
• Reset to factory settings via RESET button
• Docking station
• Errors on one network side do not have an effect on the opposite network side but can be
diagnosed.
PN/MF Coupler
Hardware Installation and Operating Manual, 07/2020, A5E50018670-AA
Product overview
2.3 Properties
17
Advertisement
Table of Contents
