Mitsubishi Electric MELDAS C6 Programming Manual page 5

CAUTION
Turn the mirror image ON and OFF at the mirror image center.
If the tool offset amount is changed during automatic operation (including during single
block stop), it will be validated from the next block or blocks onwards.
3. Items related to programming
The commands with "no value after G" will be handled as "G00".
" ; " "EOB" and " %" "EOR" are explanatory notations. The actual codes are "Line feed"
and "%" for ISO, and "End of block" and "End of Record" for EIA.
When creating the machining program, select the appropriate machining conditions, and
make sure that the performance, capacity and limits of the machine and NC are not
exceeded. The examples do not consider the machining conditions.
Do not change fixed cycle programs without the prior approval of the machine
manufacturer.
When programming the multi-part system, take special care to the movements of the
programs for other part systems.