Mitsubishi Electric MELDAS C6 Programming Manual page 336

Appendix 2. Program Error
Error No.
P203 CONF. ERR (MRC)
The compound type fixed cycle I (G70 to
G73) shape program could not cut the work
normally because it defined an abnormal
shape.
P204 C-FORMAT ERR
A command value of the compound type
fixed cycle (G70 to G76) is illegal.
P210 NO PAT CYC SPC
A compound type fixed cycle II (G74 to
G76) command was input although it was
undefined in the specification.
P220 NO SPECIAL CYC
No special fixed cycle specifications are
available.
P221 NO HOLE (S-CYC)
A 0 has been specified for the number of
holes in special fixed cycle mode.
P222 G36 ANGLE ERR
A G36 command specifies 0 for angle
intervals.
P223 G12, G13 R ERR
The radius value specified with a G12 or G13
command is below the compensation amount.
P224 NO G12, G13 SPEC
There are no circular cutting specifications.
P230 NESTING OVER
A subprogram has been called 8 or more
times in succession from the subprogram.
P231 NO N-NUMBER
At subprogram call time, the sequence
number set at return from the subprogram
or specified by GOTO, was not set.
P232 NO PROGRAM NO.
The subprogram has not been set when the
subprogram is called.
P241 NO VARI NUMBER
The variable number commanded is higher
than the numbers in the specifications.
P242 EQL. SYM. MSSG.
The "=" sign has not been commanded
when a variable is defined.
P243 VARIABLE ERR
An invalid variable has been specified in the
left or right side of an operation expression.
P260 NO COOD-RT SPC
The coordinate rotation command was
issued when the coordinate rotation
specifications were not available.
Details
328
Remedy
• Check the compound type fixed cycle I (G70
to G73) shape program.
• Check the compound type fixed cycle (G70 to
G76) command value.
• Check the specification.
• Check the specifications.
• Review the program.
• Review the program.
• Review the program.
• Check the specifications.
• Check the number of subprogram calls and
correct the program so that it does not exceed
8 times.
• Specify the sequence numbers in the call
block of the subprogram.
• When using the IC card, check the program in
the IC card and the number of IC card
program calls.
• Enter the subprogram.
• Check the program number in the IC card.
• Check the specifications.
• Check the program variable number.
• Designate the "=" sign in the variable
definition of the program.
• Correct the program.
• Check the specifications.