Mitsubishi Electric MELDAS C6 Programming Manual page 149

12. Tool Offset Functions
If all of the line vectors for
the interference avoidance
are deleted, create a new
avoidance vector as shown
on the right to avoid the
interference.
In the case of the figure below, the groove will be left uncut.
Interference
avoidance path
Tool center path
Program path
Tool center path
Program path
Tool center path 2
r2
Tool center path 1
141
12.3 Tool radius compensation
Avoidance
N3 vector
Avoidance
N1
vector
N4
r2
r1
N3
Avoidance vector 1
Avoidance vector 2
r1
N1
Program path
N2
N2