12. Tool Offset Functions
Tool offset No. (H/D)
This address designates the tool offset No.
(1) H is used for the tool length offset, and D is used for the tool position offset and tool diameter
offset.
(2) The tool offset No. that is designated once does not change until a new H or D is designated.
(3) The offset No. can be commanded once in each block. (If two or more Nos. are commanded,
the latter one will be valid.)
(4) The No. of offset sets that can be used will differ according to the machine.
For 40 sets: Designate with the H01 to H40 (D01 to D40) numbers.
(5) If a value larger than this is set, the program error "P170" will occur.
(6) The setting value ranges are as follows for each No.
The offset amount for each offset No. is preset with the setting and display unit.
Input setting
unit
#1015 cunit=100
#1015 cunit=10
Shape offset amount
Metric system
Inch system
±99999.99mm
±9999.999 inch
±9999.999mm
±999.9999 inch
101
12.1 Tool offset
Wear offset amount
Metric system
Inch system
±9999.99 mm
±999.999 inch
±999.999 mm
±99.9999 inch