Mitsubishi Electric MELDAS C6 Programming Manual page 215

13. Program Support Functions
Feed hold, feedrate override, G09 valid/invalid
By substituting the values below in variable number #3004, it is possible to make the feed hold,
feedrate override and G09 functions either valid or invalid in the subsequent blocks.
Contents (value)
(Note 1) Variable number #3004 is set to zero by NC reset.
(Note 2) The functions are valid when the above bits are 0 and invalid when they are 1.
Message display and stop
By using variable number #3006, the execution is stopped after the previous block has been
executed and, if message display data have been commanded, then the corresponding message
will be indicated on the operator message area.
Format
#3006 = 1 ( TAKE FIVE ) :
TAKE FIVE
The message should not be longer than 31 characters and it should be enclosed within round ( )
parentheses.
Mirror image
By reading variable number #3007, it is possible to ascertain the status of mirror image at a
particular point in time for each axis.
The axes correspond to the bits of #3007.
When the bits are 0, it means that the mirror image function is not valid; when they are 1, it means
that it is valid.
#3007
Bit 15
nth axis
#3004
Feed hold
0
1 Invalid
2
3 Invalid
4
5 Invalid
6
7 Invalid
Message
14 13 12 11 10
207
13.5 User macro specifications
Bit 0 Bit 1
Feedrate override
Valid Valid
Valid
Valid Invalid
Invalid
Valid Valid
Valid
Valid Invalid
Invalid
9 8 7 6
Bit 2
G09 check
Valid
Valid
Valid
Valid
Invalid
Invalid
Invalid
Invalid
5 4 3 2 1
6 5 4 3 2
0
1