Mitsubishi Electric MELDAS C6 Programming Manual page 16

3. Data Formats
Item
Program number
Sequence number
Preparatory function
Input
setting unit
Movement
axis
Input
setting unit
Input
setting unit
Additional
axis
Input
setting unit
Input
setting unit
Dwell
Input
setting unit
Input
setting unit
Feed
function
Input
setting unit
Input
setting unit
Fixed
cycle
Input
setting unit
Tool offset
Miscellaneous function
Spindle function
Tool function
2nd miscellaneous function
Subprogram
Variable number
(Note 1) α represents one of the additional axes U, V, W, A, B, or C.
(Note 2) The No. of digits check for a word is carried out with the maximum number of digits of that address.
(Note 3) The basic format is the same for any of the numerals input from the memory, MDI or setting display unit.
(Note 4) Numerals can be used without the leading zeros.
(Note 5) The program number is commanded with single block. It's necessary to command the program number
in the head block of each program.
(Note 6) The meanings of the details are as follows :
Example 1 : 08
Example 2 : G21
Example 3 : X+53
For example, the case for when the X axis is positioned (G00) to the 45.123 mm position in the absolute
value (G90) mode is as follows:
G00 X45.123 ;
Metric command
X+52 Y+52 Z+52 α+52
0.01(°), mm
0.001(°), mm/
X+53 Y+53 Z+53 α+53
0.0001 inch
0.01(°), mm I+52 J+52 K+52
0.001(°), mm/
I+53 J+53 K+53
0.0001 inch
0.01(rev), mm X53 P8
0.001(rev),
mm/ X53 P8
0.0001 inch
0.01(°), mm F53
0.001(°), mm/
F53
0.0001 inch
0.01(°), mm R+52 Q52 P8 L4
0.001(°), mm/
R+53 Q53 P8 L4
0.0001 inch
:8-digit program number
:Dimension G is 2 digits to the left of the decimal point, and 1 digit to the right.
:Dimension X uses + or - sign and represents 5 digits to the left of the decimal
point and 3 digits to the right.
3 digits below the decimal point
5 digits above the decimal point, so it's +00045, but the leading zeros and the mark
(+) have been omitted.
G0 is possible, too.
O8
N5
G2/G21
X+44 Y+44 Z+44 α+44
I+44 J+44 K+44
X53 P8
F44
R+44 Q+44 P8 L4
H3/D3
M8
S6/S8
T8
A8/B8/C8
P8H5L4
#5
8
3.2 Program formats
Inch command