Mitsubishi Electric MELDAS C6 Programming Manual page 341

Appendix 2. Program Error
Error No.
P602 NOMULTI SKIP
A multiple skipping command (G31.1,
G31.2 or G31.3) was issued though there
are no such command specifications.
P603 SKIP SPEED F0
The skip speed is 0.
P604 TLM ILL. AXIS command
No axis or more than one axis was specified
in the automatic tool length measurement
block.
P605 T-CMD IN BLOCK
The T code is in the same block as the
automatic tool length measurement block.
P606 NO T-CMD BEFOR
The T code was not yet specified in
automatic tool length measurement.
P607 TLM ILL. SIGNL
Before the area specified by the D
command or decelerating area parameter d,
the measurement position arrival signal
went ON. The signal remains OFF to the
end.
P608 SKIP ERROR (CC)
A skip command was specified during tool
radius compensation processing.
ILLEGAL PARA.
P610
• G114.1 was commanded when the spindle
synchronization with PLC I/F command
was selected.
• Spindle synchronization was commanded
to a spindle that is not connected serially.
REGARD A POINT
P701
A decimal point was added to a decimal
point invalid address.
P990 PRE-CALCULATION ERROR
combining commands that required
pre-reading (nose R offset, corner
chamfering corner R, geometric I,
geometric IB, and compound type fixed
cycle commands) resulted in eight or more
pre-read blocks.
Details
333
Remedy
• Check the specifications.
• Specify the skip speed.
• Specify one axis.
• Specify this T code before the automatic tool
length measurement block.
• Specify this T code before the block.
• Check the program.
• Specify a diameter cancel (G40) command,
or remove the skip command.
• Check the program.
• Check the argument of G114.1 command.
• Check the state of spindle connection.
• Do not add a decimal point to the decimal
point invalid address.
• Reduce the number of commands that
require pre-reading or delete such
commands.