Table of Contents
Advertisement
Control Buttons
Table 1 Control buttons on U9401A (press down model)
1
2
3
4
Table 2 Control buttons on U9402A (vacuum model)
1
2
1
Press EMERGENCY STOP in an emergency
to release the vacuum fixture.
2
Press TEST1 to run a test.
TEST2 is used only for dual-well fixtures.
3
Press ABORT1 to stop the test.
4
Press RETEST1 to run a test.
Medalist i1000 Installation Guide
2
3
1
Press EMERGENCY STOP in an emergency to release the press.
Press both DOWN buttons simultaneously to lower the press.
Press UP to raise the press.
Press RETEST to run a test.
3
4
1
2
3
4
5
6
7
8
4
2
1
2
5
6
MANUAL – Initiate manual mode for fixture installation.
FIXTURE LOCK – Lock or release the fixture.
MODUAL RELEASE – Release or lock the module holder.
MODUAL UP/DN – Raise or lower the module support.
The light is on when the module support is raised.
AUTO RELEASE – Automatically disengage and release the fixture.
AUTO LINK – Automatically lock and engage the fixture.
MOTOR RELEASE – Disengage the module from the tester
interface.
MOTOR LINK – Press and hold to engage the module.
3
4
7
8
19
Advertisement
Table of Contents
