Agilent Technologies Medalist i1000 Installation Manual page 23

6
Figure 26 Secure the top plate
7
Figure 27 Secure alignment bars
8
9
Medalist i1000 Installation Guide
Insert the screw through the slot of the top plate into the center hole
of the honeycomb plate and tighten it. Do the same on the other side.
Secure the alignment bars to hold the fixture firmly in place.
Connect the 64- pin flat cables from the back of the fixture to the
testhead. Connect the cables according to the slot numbers shown on
the back of the fixture.
Turn the sensor switch back on.
21