Agilent Technologies Medalist i1000 Installation Manual page 9

Before you begin installation, prepare the power cable for the system.
Refer to the instructions in
continue with the installation procedure for your system:
•
•
Installation Procedure for Press Down Model (U9401A)
1
2
3
4
5
6
7
8
9
Installation procedure for Vacuum Model (U9402A)
1
2
3
4
5
6
7
Medalist i1000 Installation Guide
Installation Procedure for Press Down Model (U9401A)
Installation procedure for Vacuum Model (U9402A)
Install the Press Down Unit (U9401A)
Install the Controller
Connect the Debug Probe
Connect Power and Compressed Air Supply
Power Up the System
Install Medalist i1000 Software
Install the Fixture
Align the Safety Sensors
Perform a System Check
Install the Controller
Connect the Debug Probe
Connect Power and Compressed Air Supply
Power Up the System
Install Medalist i1000 Software
Install the Fixture
Perform a System Check
"Preparing the Power Cord" on page 8. Then
7