Agilent Technologies Medalist i1000 Installation Manual page 14

Figure 14 Control cable and compressed air hose
(a)
5
Figure 15 Sensor
Install the Controller
1
12
Install the pair of safety sensors on the arms at either side of the Press
Down Unit.
Set up the monitor (Figure
Attach the collar to the back of the monitor with the four screws
a
provided.
Clamp the base to the right side or back of the test station.
b
Assemble the support arm as shown. Tighten the screws with the
c
Allen key provided.
Set the monitor on top of the arm.
d
(b)
16):
Medalist i1000 Installation Guide