Agilent Technologies Medalist i1000 Installation Manual page 6

3
Figure 3 Front panel open
Removing the Front Panel
If the front panel needs to be removed, continue with the following steps.
1
Figure 4 Unfasten supporting cables
2
4
Hold the handles of the front panel and pull towards you. The front
panel opens from the top and is supported by two cables when fully
open (Figure 3).
With the door in this position, you will be able to access the power
switches and replace any cards.
Support the front panel while you loosen the screws that secure the
supporting cables to the test station
from the screws.
Once the supporting cables are released, use the handles to lift the
front panel upwards and away from the test station.
(Figure 4). Then unhook the cables
Medalist i1000 Installation Guide
supporting
cable