Agilent Technologies Medalist i1000 Installation Manual page 7

Replacing the Front Panel
Follow these steps to replace the front panel:
1
Figure 5 Replace front panel
2
Figure 6 Secure supporting cables
3
4
Medalist i1000 Installation Guide
There are two pins at the bottom of the front panel. Fit the pins into
the corresponding holes at the bottom front edge of the test station
(Figure 5).
Support the front panel while you loop the supporting cables over the
screws (Figure 3). Tighten the screws to secure the cables.
Close the front panel.
Open the side panels and secure the latches on the inside of the front
panel.
fit pin into this hole
5