Table of Contents
Advertisement
2.6.7.3
Auto-Traverse & Comprehensive rotary chairs optional add-ons
The Auto-Traverse and Comprehensive chairs have two optional add-ons.
Child Option Accessory kit for Orion Comprehensive/Auto-Traverse
The Auto-Traverse/Comprehensive rotational chairs can be configured with a child option accessory kit
including an infant car seat, monocular camera, a small-face goggle and a pediatric observation camera. The
pediatric observation camera is mounted to a pole which fits into the bracket at the footrest. The pediatric
observation camera will observe the infant in the car seat.
NOTICE the pediatric observation camera offers no eye-tracking in the software. It is strictly for observation
and recording of the patient in the chair.
Hardware setup (car seat):
1. Unscrew the head support on the chair to remove it.
2. Slide the hook through the seat belt slot of the safety seat, so that a hook is available on each side of
the infant seat.
3. Secure the infant seat and foam on top of the chair seat by attaching the hooks to the eye bolts on
the chair frame.
4. The chair's lap belt and shoulder belts may be left disconnected.
5. The patient must be secured using the infant seat's harness.
Figure 2.6-29: Sequential images of infant car seat fitting on Auto-Traverse/Comprehensive Chair (left to right)
Hardware setup (pediatric observation camera):
1. Attach the camera to the pole and attach this to the bracket at the footrest of the rotary chair.
2. Connect the USB cables to the ports on the back of the chair frame.
3. Register the pediatric observation camera as "Pediatric Observation Camera" in the the
VisualEyes™ software, following the instructions in section 2.8: Hardware registration and licensing.
NOTICE: The VNG goggles must be registered and licensed before the pediatric observation
camera.
D-0134090-A – 2022/11
VisualEyes™ - Instructions for Use - EN
Page 38
Advertisement
Table of Contents
