Vorteq™ 2Nd Eneration Imu (Optional) - Interacoustics VisualEyes 505 Instructions For Use Manual

2.6.6 VORTEQ™ 2nd eneration IMU (optional)
The VORTEQ™ 2 Generation IMU is delivered with the VORTEQ™ Assessment and VORTEQ™
nd
Diagnostic modules, and is used to measure the patient's head movement and positioning in space during
testing. The VORTEQ™ Assessment module can be added to VisualEyes™ 505, 515, and 525, and the
VORTEQ™ Diagnostic module can be added to VisualEyes™ 525.
The VORTEQ™ 2 Generation IMU can be connected to the computer either by USB cable or wirelessly
nd
through Bluetooth with the accompanying Bluetooth receiver dongle.
The IMU can be attached to the VNG goggle by sliding the IMU into the goggle mount. The VORTEQ™ 2
Generation IMU is not compatible with the front mount goggle.
VORTEQ™ Assessment also comes with a headband used for Dynamic Visual Acuity testing. This has a
similar mount for the IMU as the one attached to the VNG goggles.
Figure 2.6-17: VORTEQ™ 2 nd
Visual Acuity (right)
The VORTEQ™ 2 Generation IMU has four LEDs that describe the status of the device:
nd
ON:
•
CHARGING:
•
BLE Broadcasting:
•
BLE Connected:
•
Figure 2.6-18: VORTEQ™ 2 nd
Hardware setup:
1. Connect the USB cable to VORTEQ™ 2
2. Connect the other end of the USB cable to the computer or the USB hub.
3. Power on the IMU by sliding the power switch.
4. Register the VORTEQ™ 2
software, following the instructions in section 2.8: Hardware registration and licensing.
NOTICE: The VNG goggles must be registered and licensed before the VORTEQ™ 2
IMU. If prompted for a license when registering the VORTEQ™ 2
and click "close".
5. Go to System Default Settings > Head Sensor, and ensure the Head Sensor Type is set as
"Micromedical VORTEQ™ 2nd Generation IMU".
D-0134090-A – 2022/11
VisualEyes™ - Instructions for Use - EN
Generation IMU being mounted on a side mount goggle (left), and mounted on the headband for Dynamic
Flashes yellow when powered on
Blue light when the battery is charging through the connected USB cable
Flashes yellow when bluetooth is broadcasting
Flashes red when the computer has successfully connected to the device
Generation IMU with LEDs turned on
Generation IMU as "VORTEQ™ 2nd Gen" in the the VisualEyes™
nd
Generation IMU.
nd
Generation
nd
Generation IMU, leave this empty
nd
nd
Page 30