Table of Contents
Advertisement
Items
Description
Run
When this button is pressed, if current selected module's "Launch Type" is "Manual" Or
Selected:
"Auto", and the "Status" state is "Idle", the Modular SA application will be launched and
connected to the indicated CXA-m module. In addition, the configurations will be saved
into the configure file automatically.
You can select multiple items via ctrl or shift and left click. You can also use mouse or
arrow keys to change the selected module.
Delete
Delete the uninstalled module from the module list.
Refresh
Refresh the module list by searching all existing CXA-m modules.
Show/Hide
When this button is pressed, the columns of advanced settings will be shown as below,
Advanced
and the button will be displayed as "Hide Advanced Setting".
Settings
The "Update FPGA" button will be shown when the Advanced Settings is unhidden.
If you press it again, the columns of advanced settings will be hidden again.
Serial Number:
Shows the serial number of the module.
Launch Type:
Configures the start-up configuration of the software for the individual CXA-m modules
in the chassis.
There are three launch types:
• Auto:
If the launch type is "Auto", when you use command line to launch x application, the
modular SA application will be launched for the module.
• Manual:
If the launch type is "Manual", the controller can only run the Modular SA application
by pressing "Run Selected" button with the check-box for the module selected.
• Disabled:
If the launch type is "Disabled", the Modular SA application cannot be launched on
the controller by "Run selected" button.
Telnet/Socket/Physics/HiSLIP Port:
Sets the Socket Port, Physics Port, and HiSLIP Dev for each module in the list. For more
information about these settings please refer to the Programming Guide.
Launching Modular SA Application
Application Launcher
41
Advertisement
Table of Contents
