Keysight M9290A Getting Started And Troubleshooting Manual page 38

Launching Modular SA Application
Application Launcher
Hardware License Installation
Launcher starting process will check if there is any Hardware License available for
the installed modules. If there is Hardware License installed on License Manager but
not upgraded to module hardware, Launcher will check the Hardware License and
update the License to Module. A prompt box will be shown as below when Hardware
License is upgrading:
After Hardware License is upgraded to module successfully, it will be removed in
License Manager and after Launcher UI is displayed, installed option number and on
which module will be displayed on Status bar:
If you install Hardware License to License Manager after Launcher is started, you
can also upgrade Hardware License to module hardware by Launcher UI.
FPGA Updating
Launcher will check the FPGA versions on all installed modules. Following message
box will be popped up when Launcher is verifying FPGA on new found module.
If any FPGA version is different with the version required by current Modular SA,
FPGA on that module will be updated automatically. During FPGA updating, a
message box will be shown as following and the LED on that module will be in Fast
Blink mode.
38