Keysight M9290A Getting Started And Troubleshooting Manual page 42

Launching Modular SA Application
Application Launcher
Items Description
Update This key will be shown when the Advanced Settings is unhidden. It is used to update the
FPGA FPGA of all the modules that are inserted in the chassis if the FPGA version on the
module is different from the version required by Modular SA.
If there is Modular SA running on the controller, this button will be disabled and grayed
out. You need close all Modular SA instances and then use this button to update the
FPGA.
Module A panel for installing the module hardware license will be shown by pressing this button.
Licenses
The left pane shows a list of installed modules. The installed module hardware licenses
will be shown in the right pane after you selecting one module in the left pane.
App Host ID is for redeeming software licenses on a controller, Module Host ID is for
redeeming hardware licenses for a module with a controller. You will be asked to provide
these information when you are redeeming licenses.
Use "Copy" button to copy the selected module host information text for the selected
module. The copied host information can be pasted to where the host information is
needed such as getting a hard ware license for the module.
If there is any new hardware license available, the new hard ware license will be shown in
the "New HW licenses" column and the "Install All New HW License" button will be
available to install all new hard ware licenses onto modules. Please refer to
License Installation" on page 43
42
for details.
"Hardware