Table of Contents
Advertisement
Chapter 8:
8.1
Overview ........................................................................................ 8-2
8.2
Recommended Testing After Part(s) Replacement ........................ 8-3
8.3
Exhalation Port Test ....................................................................... 8-5
8.4
Total Operating Hours Transfer Procedure .................................... 8-8
8.5
Blower/Valve Calibration Procedure ............................................. 8-10
8.6
Performance Verification .............................................................. 8-12
8.7
Run-In Cycle Procedure ............................................................... 8-16
8.8
System Final Test ......................................................................... 8-18
8.9
PC or Laptop Setup Procedures .................................................. 8-37
8.10 Test Cable Usage Definitions ....................................................... 8-40
8.11
Oxygen Flow Module Test .......................................................8-41
Testing and Calibration
BiPAP Vision Service Manual
Chapter 8: Testing and Calibration
8-1
1015010
Advertisement
Table of Contents
Troubleshooting
