Table of Contents
Advertisement
BiPAP Vision Repair Kits (Continued)
NOTE 1:
All items have a quantity of one unless otherwise specified.
NOTE 2:
For specific country AC power cord ordering information, please contact Respironics
Customer Service.
NOTE 3:
The original EPROM must be removed from the circuit board and installed into the new
circuit board, unless performing an upgrade to units S/N<106K. EPROMS are included.
NOTE 4:
This item is either a Replacement Part or an Optional Upgrade for the unit.
NOTE 5:
For units from S/N 100500 to 100999, the PSS (582145) and power wiring harness
(part of 582131) must also be replaced if not already done.
NOTE 6:
For units from S/N 100500 to 100999, the PSS (582145), main power switch (582141) and the
power wire harness (part of 582131) must also be replaced.
NOTE 7:
The Inlet filter foam strip (1004493) should also be ordered with this kit.
NOTE 8:
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type recommended by the manufacturer. Dispose of used batteries
according to the manufacturer's instructions.
Chapter 7: Repair and Replacement
BiPAP Vision Service Manual
7-9
1015010
Advertisement
Table of Contents
Troubleshooting
