Nortel DMS 100 Series Maintenance Manual page 296

8-8 RSC-M trouble isolation and correction
A Warm SWACT will be performed after data
sync of active terminals.
Please confirm ("YES","Y", or "NO", "N"):
Examples of the DISP command
options, STATE and DIAGHIST. Use the STATE option with a specified state
of the RSC-M to request the system lists all RSC-Ms in the specified state. An
example of a specified state of the RSC-M is Syb B.
The following is an example of the DISP command that uses the STATE option
with a selected PM type. The system lists all XPMs of the state and PM type
requests.
>MAPCI;MTC;PM;DISP STATE state RCO2
where
Example of a MAP response:
The following is an example of the DISP command that uses the diagnostic
history (DIAGHIST) option with a selected PM type. The system lists the long
and short term diagnostic history of the selected PMs. For additional
information on maintenance uses of the DISP DIAGHIST command refer to
page Section , "The Extended Peripheral Modules Diagnostics History feature
provides a resident database to record selected diagnostic results of XPMs.
This feature captures diagnostic results that indicate XPM sanity. The data in
this database can influence DMS maintenance activities. This database
provides operating company personnel with MAP command access to data on
the accumulated results of diagnostics. Data in the history database remains
over warm, cold, and reload restarts. This feature is part of software package,
New Peripheral Maintenance. This feature is not an optional feature." on page
8-20 in this section.
>MAPCI;MTC;PM;DISP DIAGHIST RCO2
and press the Enter key.
Example of a MAP response:
297-8223-550 Standard 04.02 November 2000
state
is a PM state such as; SysB, ManB, OffL, CBsy, ISTb, or InSv
SysB RCO2 : 0, 2
The DISP command contains two