Nortel DMS 100 Series Maintenance Manual page 295

Table 8-3 Overview of RSC-M/RC02 commands at the PM level (Sheet 2 of 2)
Command Function
LOADPM Load PM
NEXT Next
OFFL Offline
PMRESET Peripheral reset
POST Post
PERFORM Perform sublevel
QUERYPM Query PM
QUIT Quit
RTS Return to service
SWACT Switch activity
TRNSL Translate
TST Test
Examples of specific RSC-M commands
This section provides examples of specified RSC-M level commands.
Example of SWACT command
SWACT without parameters for a posted RSC-M, the following response
appears at the MAP terminal:
DMS-100 Family Remote Switching Center Multi-Access Maintenance Manual XPM11 and up
RSC-M trouble isolation and correction 8-7
Description
Loads software and data in one unit or both units of a posted
RSC-M or the CMR circuit card.
Posts the RSC-M that follows in a displayed set.
Sets a posted RSC-M offline.
Resets posted RSC-M or RSC-M unit.
Posts an exact RSC-M, all RSC-Ms in a specified state, or
RSC-M peripherals as a group.
Allows operating company personnel to view details of the
performance and activity of the posted RSC-M.
Displays information on a posted RSC-M. This information
includes location, node number, associated peripheral load
name, and any associated faults. Displays information on
faults when in use with the FLT option. Displays information
about the diagnostic history when in use with the DIAGHIST
option.
Exits the current PM level of the MAP display, or cancels an
RSC-M selection.
Returns to service a P-side link, one unit or both units of a
posted RSC-M, or a CMR circuit card.
Switches RSC-M activity from the active to the inactive unit
for a posted RSC-M. The faults or previous performance of
the inactive unit determine if the SWACT controller denies
the SWACT request.
Displays information about the interface links between the
RSC-M and PLGC, or about the PCM30 links between the
RSC-M and CAS nodes.
Tests one or both units of a posted RSC-M, CMR circuit card,
or a PCM30 link to an CAS node.
When the user enters the command