General Safety Instructions - Otto Bock AxonArm Ergo 12K501 Series Instructions For Use Manual

4.3 General safety instructions

CAUTION
Non-observance of safety instructions
Personal injury/damage to the product due to using the product in certain situations.
► Observe the safety instructions and the stated precautions in this accompanying document.
CAUTION
Signs of wear and tear on the product components
Injury due to faulty control or malfunction of the product
► In the interest of preventing patient injuries and to maintain product quality, we recommend performing regu­
lar service.
► Please see the service pass for more information about the service intervals. This is included in the purchased
extended warranty packages.
CAUTION
Insufficient distance to HF communication devices (e.g. mobile phones, Bluetooth devices, WiFi
devices)
Injury due to unexpected behaviour of the product caused by interference with internal data communication.
► Therefore, keeping a minimum distance of 30 cm from HF communication devices is recommended.
CAUTION
Proximity to sources of strong magnetic or electrical interference (e.g. theft prevention systems, metal
detectors)
Injury due to unexpected behaviour of the product caused by interference with internal data communication.
► Avoid remaining in the vicinity of visible or concealed theft prevention systems at the entrance/exit of stores,
metal detectors/body scanners for persons (e.g. in airports) or other sources of strong magnetic and electric­
al interference (e.g. high-voltage lines, transmitters, transformer stations, computer tomographs, magnetic
resonance tomographs, etc.).
► When walking through theft prevention systems, body scanners or metal detectors, watch for unexpected
behaviour of the product.
CAUTION
Operating the product in very close proximity to other electronic devices
Injury due to unexpected behaviour of the product caused by interference with internal data communication.
► Do not operate the product in the immediate vicinity of other electronic devices.
► Do not stack the product with other electronic devices during operation.
► If simultaneous operation cannot be avoided, monitor the product and verify proper use in the existing setup.
CAUTION
Operator errors during the adjustment procedure
Injury due to faulty control of the Axon-Bus prosthesis system.
► Participation in an Ottobock product training course is mandatory prior to using the product. During product
training, you will receive a password which provides you with authorisation to access the 560X500=* AxonSoft
software. To qualify for software updates, additional product training courses may be necessary.
► Do not share your unlock PIN.
► Use the online help which is integrated into the software.
AxonArm Ergo 12K501=*
Safety
7