Installing A Ptx5000 Three-Phase Wye Ac Pdu Power Cord - Juniper PTX5000 Hardware Manual

Packet transport router

Hide thumbs Also See for PTX5000:

Table of Contents

the wiring compartment, remove the metal retaining bracket and AC power cord from the PDU. See

Figure 190: Removing the Metal Retaining Bracket and AC Power Cord

Installing a PTX5000 Three-Phase Wye AC PDU Power Cord

To install a three-phase wye AC power cord:

Ensure that the voltage across the AC power source is 0 V and that there is no chance that the

voltage might become active during installation.

Switch the circuit breaker and power OUTPUT switch on the PDU to the off (O) position.

Table of Contents