Juniper PTX5000 Hardware Manual page 409

1. Ensure that the voltage across the AC power source is 0 V and that there is no chance that the
voltage might become active during installation.
2. Move the power switch located on the faceplate of the PDU to the standby
(
) position.
3. Grasp the front installation handle and top installation handle, and insert the PDU into the PDU
slot. See Figure 200 on page
Figure 200: Installing a High Capacity Delta AC PDU
4. Using both hands, slide the PDU into the chassis until you feel resistance.
5. Push the front installation handle up toward the PDU, and secure the handle with the captive
screws.
6. Using a number 2 Phillips (+) screwdriver, loosen the four captive screws that secure the metal
retaining bracket to the newly installed PDU. Remove the metal retaining bracket from the PDU.
391.
391