Juniper PTX5000 Hardware Manual page 259

241
d. Using a number 2 Phillips (+) screwdriver, use the four screws on the metal retaining bracket to
secure the AC power cord to the PDU (see Figure 107 on page 241).
Figure 107: Attaching the Power Cord to the High Capacity Delta AC PDU
7. Connect the wires to the AC terminal block on the High Capacity Delta AC PDU (Figure 108 on
page 242). Using a 1/5-in. (5.5-mm) slotted screwdriver, loosen each of the input terminal screws
and the grounding point screw, insert each wire into the grounding point or input terminal, and
tighten the screw.
a. Insert the wire labeled GND into the grounding point.
b. Insert the wire labeled L1 into the L1 input terminal.
c. Insert the wire labeled L2 into the L2 input terminal.