Replacing A Cable Between A Ptx5000 Ccg And An External Clocking Device - Juniper PTX5000 Hardware Manual

6. To verify that the CCG is installed correctly and is functioning normally, check the LEDs on the CCG
faceplate. The green OK LED should light steadily. If the CCG is the primary, the blue MASTER LED
should also light steadily.
To check the status of the CCGs, use the following CLI command:
user@host> show chassis environment ccg
Figure 147: Installing a CCG
Replacing a Cable Between a PTX5000 CCG and an External Clocking
Device
IN THIS SECTION
Removing a Cable for an External Clocking Device From a PTX5000 CCG | 319
Installing a Cable Between an External Clocking Device and a PTX5000 CCG | 319
318